Bathroom Light Switch Location Code Canada

It's against code to have a light switch within 1 meter of the shower. If the shower ends up close to the door then the light switch usually just goes on the outside of the bathroom to meet code. I was just wondering if anyone knows the rule # for location of switches in bathrooms (distances away from the shower) I know i have found it before just cant find it again.

Thanks. The light switches in US bathrooms are almost always in the bathroom, whereas the light switches for Canadian bathrooms are often outside of the bathroom. It's been a long personal frustration.

How To Connect A Bathroom Light Switch | Shelly Lighting

I have a similar situation that sounds like it is not code compliant. The light switch box (3 switches - bathroom lights, shower light and heat lamp) is located approx 6" from the shower enclosure. What is your thoughts on a light switch located on wall that shares the same wall cavity as the shower plumbing.

I know current standards call out light switches should not be within 3 feet of the bath or shower. In this case the switch is but in an indirect way. I know indirect or not the switch still is too close.

Bathroom Light Switch Location – Everything Bathroom

Here is the narrative I wrote, what are your thoughts. Is this an issue or. Install the light switch in the right location: The National Electrical Code (NEC) specifies the safe location for light switches in bathrooms.

According to NEC regulations, light switches should be installed a minimum of 60 inches away from the edge of the bathtub or shower stall. The 2020 code addresses the switch location for habitable rooms, bathrooms, and kitchens in a dwelling units. If requires that the switch that controls the lighting outlet in the room be located "near an entrance to the room on a wall".

Electrical Outlet Height From Floor Code Standard | Viewfloor.co

With that in mind, let's take a look at some of the recommendations for electrical switch heights in Canada: Standard Light Switch Height Requirements With no set rules in our local building codes, how high should a light switch be? Typically, light switches are located 120 cm (4 feet) from the floor. 30-320 (1) (2) if a fixtures is install within 1.5m of a plumbing fixture it needs to be suitable for damp locations. 30-320 (3) If the switch is located within one meter of a bath tub or shower stall it needs gfci protection.

Switches cannot be installed within 500mm of a bathtub or shower stall. Common sense is another thing altogether. If the bath is too small, or the arrangement prevents you placing the switch in a sensible location, perhaps it's time to think "outside the bath." That is, place the switch near the door, but outside the bathroom.

Or, take a leaf from the outdoor lights, and put the light on a motion sensor.